The OpenFlow protocol is driven by ONF (Open Networking Foundation), a leader in software-defined networking (SDN). The OpenFlow protocol encompasses three essential components of an SDN framework:
- A physical OpenFlow switch.
- A virtual OpenFlow switch to manage virtual machines.
- An OpenFlow controller, to organize all network pieces.
The following websites provide detailed information on Open vSwitch and the OpenFlow protocol.
- Open vSwitch: http://openvswitch.org
- OpenFlow: http://www.opennetworking.org/sdn-resources/openflow
PicOS can run in two different modes:
- OVS (Open vSwitch) mode: In this mode, PicOS is dedicated and optimized for Openflow applications.
- L2/L3 (Layer 2/Layer 3) mode: In this mode, PicOS can run switching and routing protocols, as well as OpenFlow applications
In OVS mode, L2/L3 daemons are not running; the system is fully dedicated to Openflow and OVS.
In L2/L3 mode, L2/L3 daemons are running, but OVS can also be activated if CrossFlow is activated.
This chapter assumes that the PicOS OVS mode is active. Please see PicOS Mode Selection to modify the PicOS mode.
On N3048EP-ON and N3132PX switches, run "save_config" command when set OVS commands. Otherwise, the OVS configuration will be lost after PicOS reboot. For detail, please refer to Configuration Saving Guide.
- PicOS Support for OpenFlow 1.3
- PicOS Support for OpenFlow 1.3.0
- PicOS Support for OpenFlow 1.4
- PicOS Support for OpenFlow 1.4.0
- Login Interface
- Monitoring the Switch
- Adding a Bridge
- Add a Port
- Add GRE Port
- Add Group Table
- Add or Edit a Controller
- Edit Flow Tables
- Edit Lag Interface
- Basic Configuration in OVS Mode
- Configuring sFlow v5
- Configuring Port Mirroring
- OVSDB file
- OVS LLDP
- Enabling Radius in PicOS OVS Mode
- Inventory Database
- Broadcom Chip Limitation in OVS
- Ovs CLI Enhancements
- Configuring Meter
- Configuration saving
- Configuring Buffer management
- Configuring snmp
- Configuring Precision Time Protocol
- Configuring Tunneling
- Configuring Bridge and Ports
- Configuring LAG and LACP
- Configuring QoS
- Configuring Flow Table
- Configuring Group
- Configuring Controller or Manager
- Configuring Counter
- Switching Open vSwitch version
- Configuring rate limit
- Basic Bridge Configuration
- Basic Flow Configurations
- Connection to a RYU Controller
- Connection to OpenDaylight Controller
- Connection to a Floodlight Controller
- Configuration Guide for Atrium Stack on ONOS Controller