Programmable Internetworking & Communication Operating System Docs ... Click Spaces -> Space Directory to see docs for all releases ...
Page tree
Skip to end of metadata
Go to start of metadata


This section describes how to configure the force rate of an interface.

Procedure

  •     Configure the force rate of an interface.

       set interface gigabit-ethernet<interface-name> speed <speed>

Configuration Example

  •    Configure the force rate of the Te-1/1/49 port to 100 M.
admin@Xorplus# set interface gigabit-ethernet te-1/1/49 speed 100
admin@Xorplus# commit


Verify the Configuration

  •  Use run show interface gigabit-ethernet command to view the current interface status information of te-1/1/5 interface. Check the Speed and Auto-negotiation field in the command output. Auto-negotiation field is Disabled when in non-auto-negotiation mode.
admin@XorPlus# run show interface gigabit-ethernet te-1/1/5
Physical interface: te-1/1/5, Enabled, error-discard False, Physical link is Up
Interface index: 5, SFP type: unknown, Mac Learning Enabled
Description:
Link-level type: Ethernet, MTU: 1514, Speed: 1Gb/s, Duplex: Full
Source filtering: Disabled, Flow control: Disabled
Auto-negotiation: Disabled
Interface flags: Hardware-Down SNMP-Traps Internal: 0x0
Interface rate limit  ingress:unlimited, egress:unlimited
Link fault signaling  ignore local fault:false, ignore remote fault:false
force up mode:false
Precision Time Protocol mode:none
Current address: 48:6e:73:01:00:bb, Hardware address: 48:6e:73:01:00:bb
Traffic statistics:
  5 sec input rate 0 bits/sec, 0 packets/sec
  5 sec output rate 544 bits/sec, 0 packets/sec
  Input Packets............................0
  Output Packets...........................9149
  Input Octets.............................0
  Output Octets............................1125327
  • No labels