Programmable Internetworking & Communication Operating System Docs ... Click Spaces -> Space Directory to see docs for all releases ...
Page tree
Skip to end of metadata
Go to start of metadata

The run show pim interface command shows information about all interfaces or a specified interface on which PIM-SM is enabled.


Command Syntax

run show pim interface [address <ip-address>]


Parameter

Parameter

Description

address <ip-address>

Optional. Specifies the interface IP address on which PIM-SM is enabled.


Example

  • Show information about all interfaces on which PIM-SM is enabled.
admin@Xorplus# run show pim interface
Interface    State   Mode    V   PIMstate   Priority   DRaddr            Neighbors
----------   --------   ------   -   --------   --------   ---------------   ---------
loopback     UP         Sparse   2   DR         1          1.1.1.1           0       
vlan20       UP         Sparse   2   NotDR      1          20.0.0.2          1       
vlan60       UP         Sparse   2   NotDR      1          60.0.0.3          1       
vlan100      UP         Sparse   2   DR         1          100.0.0.1         0      

Table 1 Description of the run show pim interface command output

Item

Description

Interface

Indicates interfaces that enabled PIM-SM.

State

Indicates the state of the PIM interface, UP or DOWN.

Mode

Indicates that mode of the PIM protocol, Sparse or Dense. Currently the only Sparse mode is supported.

V

Indicates the version of PIM protocol. Currently the only PIM version 2 is supported.

PIMstate

Indicates whether the interface is DR or not.

Priority

Indicates DR priority.

DRaddr

Indicates DR IP address.

Neighbors

Indicates the total number of PIM neighbors on the interface.

  • No labels