Programmable Internetworking & Communication Operating System Docs ... Click Spaces -> Space Directory to see docs for all releases ...
Page tree
Skip to end of metadata
Go to start of metadata

To enable OSPF on an interface and assign the interface to an area, use the set protocols ospf4 area interface vif address command in L2/L3 configuration mode. The interface will send and accept OSPF LSAs (link-state advertisements).

Command Syntax

set protocols ospf4 vrf vrf-name area area-id interface interface-name vif vif-name address ip-address

Parameters

vrf-name

Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>].

Note that: The configuration is in the default VRF if not explicitly bound to any VRF.

area-idOSPF area identifier. Use the dotted decimal notation. For example, use 0.0.0.0 for area 0.
interface-nameInterface name.
vif-nameVirtual interface name.
ip-addressVirtual interface IP address used for OSPF.

Example

The following example assigns interfaces vlan2 and vlan3 to OSPF area 0:

admin@Switch# set protocols ospf4 area 0.0.0.0 interface vlan2 vif vlan2 address 10.2.2.1
admin@Switch# set protocols ospf4 area 0.0.0.0 interface vlan3 vif vlan3 address 10.3.3.1
  • No labels