Programmable Internetworking & Communication Operating System Docs ... Click Spaces -> Space Directory to see docs for all releases ...
Page tree
Skip to end of metadata
Go to start of metadata

To configure the interval between two OSPF hello messages sent by an interface, use the set protocols ospf4 area interface vif address hello-interval command in L2/L3 configuration mode.

Command Syntax

set protocols ospf4 vrf vrf-name area area-id interface interface-name vif vif-name address ip-address hello-interval time

Parameters

vrf-name

Optional. Specifies a VRF name. The value is a string. It’s a user-defined VRF set by the command set ip vrf <vrf-name> [description <string>].

Note that: The configuration is in the default VRF if not explicitly bound to any VRF.

area-idOSPF area identifier.
interface-nameInterface name.
vif-nameVirtual interface name.
ip-addressVirtual interface IP address used for OSPF.
timeThe OSPF hello interval in seconds. The range is 1-65535.

Example

The following example sets the OSPF hello interval to 20 seconds:

admin@Switch# set protocols ospf4 area 0.0.0.0 interface vlan2 vif vlan2 address 10.2.2.1 hello-interval 20
  • No labels