Programmable Internetworking & Communication Operating System Docs ... Click Spaces -> Space Directory to see docs for all releases ...
Page tree
Skip to end of metadata
Go to start of metadata

The set protocols vrrp interface vif vrid command creates a VRRP group. 

NOTE:

This command applies to both VRRPv2 and VRRPv3 configuration.


Command Syntax

set protocols vrrp interface <interface-name> vif <vif-namevrid <virtual-router-id>

 

Parameter

Parameter

Description

interface <interface-name>

Specifies the Layer 3 interface name of VRRP device. The value is a string.

vif <vif-name>

Specifies the VLAN interface name. The value is a string.

vrid <virtual-router-id>

Specifies the VRID of a VRRP group. The value is an integer that ranges from 1 to 254.

 

Usage Guidelines

When configuring VRID, pay attention to the following points:

  •   A VRID identifies the devices of the same VRRP group. Two devices in a VRRP group must be configured with the same VRID.
  •   It is recommended that VRRP groups on different VLAN interfaces of a device should be configured with different VRIDs. 
  •   One chassis switch supports a maximum of 128 VRRP groups. Please set the number of VRRP group based on device performance.
  •   Currently, VRRP can be configured only on the VLAN interface.


Example

  •  Create a VRRP group on vlan100 with VRID 2. 
admin@Xorplus# set protocols vrrp interface vlan100 vif vlan100 vrid 2
admin@Xorplus# commit
  • No labels