The set protocols vrrp interface vrid ipv6-nd managed-config-flag command controls flag setting in RAs the router transmits on the current interface. Enable the flag to indicate that hosts can obtain IP address through DHCPv6. The flag is disabled by default.
The delete protocols vrrp interface vrid ipv6-nd managed-config-flag command restores the default configuration.
set protocols vrrp interface <interface-name> vrid <virtual-router-id> ipv6-nd managed-config-flag
Specifies the Layer 3 interface name of VRRP device. The value is a string.
Specifies the VRID of a VRRP group. The value is an integer that ranges from 1 to 254.
- Configure the flag in IPv6 router advertisements which indicates to hosts that they should use managed (stateful) protocol for addresses autoconfiguration in addition to any addresses autoconfigured using stateless address autoconfiguration.
admin@Xorplus# set protocols vrrp interface vlan100 vrid 2 ipv6-nd managed-config-flag admin@Xorplus# commit