To configure jitter for regular RIP update interval, use the set protocols rip interface vif address update-jitter in L2/L3 configuration mode.

Command Syntax

set protocols rip interface interface-name vif vif-name adress ip-address update-jitter percent

Parameters

interface-nameInterface name.
vif-nameVirtual interface name.
ip-addressVirtual interface IP address used for RIP.
percentJitter as a percentage of RIP update-interval. The range is 0-100.

Example

The following example configures jitter as 10 percent of the RIP update-interval:

admin@Switch# set protocols rip interface vlan10 vif vlan10 address 10.1.1.1 update-jitter 10