The set firewall filter copp sequence from destination-address-ipv4 command configures a firewall filter rule based on the destination IPv4 address for traffic classification.
set firewall filter copp sequence <number> from destination-address-ipv4 <ipv4-address>
Specifies filter sequence number. The value is an integer that ranges from 0 to 9999.
The 15 integers 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110, 120, 130, 140, 150 are not allowed to be used for sequence numbers in user-defined CoPP firewall filter rules.
destination-address-ipv4 < ipv4-address>
Specifies destination IP, it could be a specific IPv4 address or an IPv4 subnet. For example, 192.168.1.10, 10.1.1.0/24.
You can run the set firewall filter copp sequence from destination-address-ipv4 command to configure a firewall filter rule based on the destination IPv4 address for traffic classification so that the device processes packets matching the same firewall filter rule in the same manner.
• Configure a firewall filter rule based on the destination IPv4 address of 10.1.1.0/24.
admin@XorPlus# set firewall filter copp sequence 51 from destination-address-ipv4 10.1.1.0/24 admin@XorPlus# commit