The copy running-config startup-config command saves the running configuration file from the RAM to the flash.

Warning:

This command is supported only on N3048EP-ON, N3048ET-ON, N1148T-ON and N3132PX switches, and you have to do configuration saving by running this command. This specific save command is requested by hardware vendor due to the Flash limitation on numbers of write/erase cycles.

Command Syntax

copy running-config startup-config


Parameter

None.


Usage Guidelines

When performing the following operations, you need to manually issue the configuration saving command to save the configuration file from the RAM to the flash.

You can use two commands to save your configuration, the save_config command or the copy command:

admin@Xorplus$ sudo save_config
admin@Xorplus> copy running-config startup-config


Example

•  Save the running configuration file from the RAM to the flash after setting the L2 / L3 CLI commands.

admin@Xorplus# set protocols vrrp interface vlan100 vif vlan100 vrid 2 disable true
admin@Xorplus# set protocols vrrp interface vlan100 vif vlan100 vrid 2
admin@Xorplus# commit
Merging the configuration.
Commit OK.
Save done.
admin@Xorplus# quit
admin@Xorplus> copy running-config startup-config