The run show msdp peer command displays the status information about the MSDP peers.

Note that: Use this command only on MSDP peers.


Command Syntax

run show msdp peer [<peer-ip> | detail]


Parameter

Parameter

Description

<peer-ip>

Optional. Specifies the address of a remote MSDP peer. If this parameter is not specified, information about all the MSDP peers will be displayed.

The address is in dotted decimal notation.

detail

Optional. Displays detail information about the status of MSDP peers.


Example

admin@Xorplus# run show msdp peer
Peer                       Local        State    Uptime   SaCnt
3.3.3.3                  2.2.2.2  established  06:10:45       2
admin@Xorplus# run show msdp peer detail
Peer : 3.3.3.3
  Local               : 2.2.2.2
  Mesh Group          : 6.6.6.6
  State               : established
  Uptime              : 06:10:52
  Keepalive Timer     : 00:00:08
  Conn Retry Timer    : --:--:--
  Hold Timer          : 00:00:46
  Last Reset          : -
  Conn Attempts       : 22
  Established Changes : 1
  SA Count            : 2
  Statistics          :
                       Sent       Rcvd
    Keepalives :        371          4
    SAs        :          0        748
admin@Xorplus# run show msdp peer 3.3.3.3
Peer : 3.3.3.3
  Local               : 2.2.2.2
  Mesh Group          : 6.6.6.6
  State               : established
  Uptime              : 06:11:03
  Keepalive Timer     : 00:00:57
  Conn Retry Timer    : --:--:--
  Hold Timer          : 00:00:35
  Last Reset          : -
  Conn Attempts       : 22
  Established Changes : 1
  SA Count            : 2
  Statistics          :
                       Sent       Rcvd
    Keepalives :        372          4
    SAs        :          0        748